Element 8 Question 8-26C5
C8C26: Power Supplies
When monitoring the gate voltage of a power MOSFET in the switching power supply of a modern RADAR, you would expect to see the gate voltage change from “low” to “high” by how much?
- 1 volt to 2 volts.
- 300 microvolts to 700 microvolts.
- Greater than 2 volts. (correct answer)
- 1.0 volt to 20.0 volts.
Correct answer: C, Greater than 2 volts.
Explanation
A power MOSFET needs a gate-to-source voltage above its threshold, typically about 2–4 V, before it conducts. To drive it fully on with low on-resistance, the gate driver normally swings it about 10–15 V. So on a scope you should see a clean gate transition from low to high of well over 2 V. A small swing points to a bad driver or a shorted gate.
Why the other answers are wrong
- A, 1 volt to 2 volts.: A 1–2 V swing is at or below a typical gate threshold. The MOSFET would barely conduct or stay off, so it would not switch properly.
- B, 300 microvolts to 700 microvolts.: Microvolt changes are far too small to switch any power MOSFET. They are noise-level signals, not gate drive.
- D, 1.0 volt to 20.0 volts.: This range starts at 1 V, which is too little to turn the device on. It mixes absolute levels with the size of the swing, so it doesn't describe the expected transition.