Element 8 Question 8-49F2
C8F49: Installation
RADAR interference to a communications receiver is eliminated by:
- Not operating other devices when RADAR is in use.
- Properly grounding, bonding, and shielding all units. (correct answer)
- Using a high pass filter on the power line.
- Using a link coupling.
Correct answer: B, Properly grounding, bonding, and shielding all units.
Explanation
A radar's modulator and transmitter generate sharp, high-power pulses rich in harmonics. These can couple into nearby receivers by radiation, through power lines and through shared ground paths. Several measures block those paths together. Bonding all equipment cases to a common low-impedance ground, shielding cables and enclosures, and grounding the shields keeps the pulse energy away from communications receivers.
Why the other answers are wrong
- A, Not operating other devices when RADAR is in use.: Shutting down other equipment isn't a practical cure. The interference must be suppressed at its source and along its coupling paths.
- C, Using a high pass filter on the power line.: Pulse noise on power lines is high-frequency energy. A high-pass filter would pass that noise, while a low-pass filter is the type used to block it.
- D, Using a link coupling.: Link coupling is a method of transferring RF between circuits. It does nothing to stop radar pulse energy reaching other receivers.