Element 8 Question 8-49F3
C8F49: Installation
Why should long horizontal runs of waveguide be avoided?
- They must be insulated to prevent electric shock.
- To prevent damage from shipboard personnel.
- To minimize reception of horizontally polarized returns.
- To prevent accumulation of condensation. (correct answer)
Correct answer: D, To prevent accumulation of condensation.
Explanation
Moisture inside a waveguide condenses and collects at low points, and long horizontal sections give it a place to pool. Water in the guide increases loss, causes reflections and arcing, and corrodes the conductive walls. Good installation practice keeps runs as vertical and short as practical. Any horizontal section should be sloped slightly so condensation drains, with a drain point at the low end where needed.
Why the other answers are wrong
- A, They must be insulated to prevent electric shock.: The waveguide is a grounded metal conductor and normally carries no shock hazard. Insulation is not the concern.
- B, To prevent damage from shipboard personnel.: Mechanical protection is needed for any run. It is not a reason to avoid horizontal routing in particular.
- C, To minimize reception of horizontally polarized returns.: The orientation of the feeder run has no effect on the antenna's polarization or on which returns it receives.