Amateur Extra Question E4C06
E4C: Receiver performance: phase noise, noise floor, image rejection, minimum detectable signal (MDS), increasing signal-to-noise ratio and dynamic range, noise figure, reciprocal mixing; selectivity; SDR non-linearity; use of attenuators at low frequencies
How much does increasing a receiver’s bandwidth from 50 Hz to 1,000 Hz increase the receiver’s noise floor?
- 3 dB
- 5 dB
- 10 dB
- 13 dB (correct answer)
Correct answer: D, 13 dB
Explanation
Noise power is proportional to bandwidth, so the noise floor change in dB is 10 log of the bandwidth ratio: 10 log(1,000 Hz / 50 Hz) = 10 log(20) = 13 dB. As a check, each doubling of bandwidth adds about 3 dB and each tenfold increase adds 10 dB. A 20-times increase is therefore 10 dB + 3 dB.
Why the other answers are wrong
- A, 3 dB: 3 dB is the increase for doubling the bandwidth, but 50 Hz to 1,000 Hz is a 20-fold increase.
- B, 5 dB: 5 dB corresponds to only about a 3.2-fold bandwidth increase, far less than the 20-fold change from 50 Hz to 1,000 Hz.
- C, 10 dB: 10 dB is the increase for a tenfold change, such as 100 Hz to 1,000 Hz; starting at 50 Hz doubles the ratio again and adds another 3 dB.