Amateur Extra Question E4C07
E4C: Receiver performance: phase noise, noise floor, image rejection, minimum detectable signal (MDS), increasing signal-to-noise ratio and dynamic range, noise figure, reciprocal mixing; selectivity; SDR non-linearity; use of attenuators at low frequencies
What does the MDS of a receiver represent?
- The meter display sensitivity
- The minimum discernible signal (correct answer)
- The modulation distortion specification
- The maximum detectable spectrum
Correct answer: B, The minimum discernible signal
Explanation
MDS, the minimum discernible signal, is the weakest signal a receiver can detect. It is usually defined as the input level that equals the receiver's noise floor, giving a 3 dB rise in output. It depends on noise figure and bandwidth: MDS (dBm) = -174 + NF + 10 log(BW). For example, NF 10 dB and 500 Hz gives -174 + 10 + 27 = -137 dBm.
Why the other answers are wrong
- A, The meter display sensitivity: Meter display sensitivity is not a standard receiver specification; MDS concerns the weakest detectable signal, not how the S-meter reads.
- C, The modulation distortion specification: Distortion is covered by intermodulation and dynamic range specifications; MDS describes sensitivity at the weak-signal end.
- D, The maximum detectable spectrum: MDS is about the smallest detectable signal level, not a maximum, and it does not measure spectrum or frequency coverage.