Amateur Extra Question E4C08
E4C: Receiver performance: phase noise, noise floor, image rejection, minimum detectable signal (MDS), increasing signal-to-noise ratio and dynamic range, noise figure, reciprocal mixing; selectivity; SDR non-linearity; use of attenuators at low frequencies
An SDR receiver is overloaded when input signals exceed what level?
- One-half of the maximum sample rate
- One-half of the maximum sampling buffer size
- The maximum count value of the analog-to-digital converter
- The reference voltage of the analog-to-digital converter (correct answer)
Correct answer: D, The reference voltage of the analog-to-digital converter
Explanation
An SDR's analog-to-digital converter can only represent input voltages up to its reference voltage, which sets full scale. A larger input clips at the top count, flattening the waveform and spraying distortion products across the spectrum. The ADC sees every signal in its passband at once, so their combined peak must stay below that level. Attenuators, preselectors or gain control keep it there.
Why the other answers are wrong
- A, One-half of the maximum sample rate: Half the sample rate is the Nyquist limit, which sets the highest frequency that can be sampled without aliasing, not the amplitude that causes overload.
- B, One-half of the maximum sampling buffer size: Buffer size affects how much sampled data is stored and processed, not how strong an input the converter can handle.
- C, The maximum count value of the analog-to-digital converter: A digital count can never exceed its maximum; the overload limit is set at the analog input, where voltages above the reference voltage clip to that top count.