Amateur Extra Question E4C09
E4C: Receiver performance: phase noise, noise floor, image rejection, minimum detectable signal (MDS), increasing signal-to-noise ratio and dynamic range, noise figure, reciprocal mixing; selectivity; SDR non-linearity; use of attenuators at low frequencies
Which of the following choices is a good reason for selecting a high IF for a superheterodyne HF or VHF communications receiver?
- Fewer components in the receiver
- Reduced drift
- Easier for front-end circuitry to eliminate image responses (correct answer)
- Improved receiver noise figure
Correct answer: C, Easier for front-end circuitry to eliminate image responses
Explanation
The image frequency lies twice the IF away from the desired signal, on the far side of the local oscillator. With a high IF, such as 45 MHz or more, the image falls far from the wanted frequency. Even simple front-end filtering can then reject it easily. With a low IF, the image sits close by and is hard to filter out ahead of the mixer.
Why the other answers are wrong
- A, Fewer components in the receiver: A high IF usually needs a further conversion to a lower IF for narrow selectivity, so it tends to add components rather than remove them.
- B, Reduced drift: Drift depends mainly on oscillator stability; a high IF does not reduce it, and higher-frequency oscillators can be harder to keep stable.
- D, Improved receiver noise figure: Noise figure is set mainly by the first RF stages and mixer; the reason for a high IF is image rejection, not lower noise.