Amateur Extra Question E4C10
E4C: Receiver performance: phase noise, noise floor, image rejection, minimum detectable signal (MDS), increasing signal-to-noise ratio and dynamic range, noise figure, reciprocal mixing; selectivity; SDR non-linearity; use of attenuators at low frequencies
What is an advantage of having a variety of receiver bandwidths from which to select?
- The noise figure of the RF amplifier can be adjusted to match the modulation type, thus increasing receiver sensitivity
- Receiver power consumption can be reduced when wider bandwidth is not required
- Receive bandwidth can be set to match the modulation bandwidth, maximizing signal-to-noise ratio and minimizing interference (correct answer)
- Multiple frequencies can be received simultaneously if desired
Correct answer: C, Receive bandwidth can be set to match the modulation bandwidth, maximizing signal-to-noise ratio and minimizing interference
Explanation
Noise power rises with bandwidth. A filter wider than the signal admits extra noise and nearby signals without adding any wanted energy. Matching the bandwidth to the mode keeps all the desired signal while rejecting as much noise and interference as possible, which maximizes signal-to-noise ratio. Typical widths are a few hundred hertz for CW, about 2.4 kHz for SSB, and wider for AM or FM.
Why the other answers are wrong
- A, The noise figure of the RF amplifier can be adjusted to match the modulation type, thus increasing receiver sensitivity: Bandwidth selection is done by IF or DSP filters later in the receiver; it does not change the RF amplifier's noise figure.
- B, Receiver power consumption can be reduced when wider bandwidth is not required: Selectable filters exist to improve reception, not to save power; their effect on power consumption is negligible.
- D, Multiple frequencies can be received simultaneously if desired: Choosing a filter width sets how much of one channel you hear; receiving separate frequencies at once needs dual receivers or a wideband SDR.