Amateur Extra Question E4C12
E4C: Receiver performance: phase noise, noise floor, image rejection, minimum detectable signal (MDS), increasing signal-to-noise ratio and dynamic range, noise figure, reciprocal mixing; selectivity; SDR non-linearity; use of attenuators at low frequencies
How does a narrow-band roofing filter affect receiver performance?
- It improves sensitivity by reducing front-end noise
- It improves intelligibility by using low Q circuitry to reduce ringing
- It improves blocking dynamic range by attenuating strong signals near the receive frequency (correct answer)
- All these choices are correct
Correct answer: C, It improves blocking dynamic range by attenuating strong signals near the receive frequency
Explanation
A roofing filter sits right after the first mixer and has a narrow bandwidth. It keeps strong nearby signals out of the later amplifiers, mixers and DSP stages, so those signals cannot drive the stages into compression. Because the receiver tolerates stronger near-frequency signals before it desensitizes, the blocking dynamic range improves.
Why the other answers are wrong
- A, It improves sensitivity by reducing front-end noise: Sensitivity is set mainly by the noise figure of the early stages; a filter after the mixer does not lower front-end noise.
- B, It improves intelligibility by using low Q circuitry to reduce ringing: Narrow filters are high Q, and high Q tends to cause ringing, not reduce it; this statement is false.
- D, All these choices are correct: Only the blocking dynamic range statement is true; the claims about lower front-end noise and low-Q circuitry are false.