Amateur Extra Question E4C13
E4C: Receiver performance: phase noise, noise floor, image rejection, minimum detectable signal (MDS), increasing signal-to-noise ratio and dynamic range, noise figure, reciprocal mixing; selectivity; SDR non-linearity; use of attenuators at low frequencies
What is reciprocal mixing?
- Two out-of-band signals mixing to generate an in-band spurious signal
- In-phase signals cancelling in a mixer resulting in loss of receiver sensitivity
- Two digital signals combining from alternate time slots
- Local oscillator phase noise mixing with adjacent strong signals to create interference to desired signals (correct answer)
Correct answer: D, Local oscillator phase noise mixing with adjacent strong signals to create interference to desired signals
Explanation
A real local oscillator has phase noise: weak noise sidebands spread out around its main frequency. A strong signal a few kHz away can mix with those sidebands and land in the IF passband. The result is a raised noise floor that masks a weak desired signal. That process is reciprocal mixing, and a cleaner, low-phase-noise oscillator reduces it.
Why the other answers are wrong
- A, Two out-of-band signals mixing to generate an in-band spurious signal: Two out-of-band signals combining into an in-band spur describes intermodulation, not reciprocal mixing.
- B, In-phase signals cancelling in a mixer resulting in loss of receiver sensitivity: Phase cancellation in a mixer is not what reciprocal mixing means; it involves the oscillator's noise sidebands, not cancellation.
- C, Two digital signals combining from alternate time slots: Combining signals from alternating time slots describes time-division multiplexing, which has nothing to do with mixer noise.