Amateur Extra Question E4C14
E4C: Receiver performance: phase noise, noise floor, image rejection, minimum detectable signal (MDS), increasing signal-to-noise ratio and dynamic range, noise figure, reciprocal mixing; selectivity; SDR non-linearity; use of attenuators at low frequencies
What is the purpose of the receiver IF Shift control?
- To permit listening on a different frequency from the transmitting frequency
- To change frequency rapidly
- To reduce interference from stations transmitting on adjacent frequencies (correct answer)
- To tune in stations slightly off frequency without changing the transmit frequency
Correct answer: C, To reduce interference from stations transmitting on adjacent frequencies
Explanation
IF Shift slides the receiver's IF passband up or down relative to the signal you are tuned to. The receive frequency stays the same. You can move the filter edge away from an interfering station just above or below, cutting that interference while keeping most of the wanted signal.
Why the other answers are wrong
- A, To permit listening on a different frequency from the transmitting frequency: Listening on a frequency different from the transmit frequency is the job of RIT or split operation, not IF Shift.
- B, To change frequency rapidly: Fast tuning is done with the main tuning knob, step size or band memories; IF Shift does not change the operating frequency.
- D, To tune in stations slightly off frequency without changing the transmit frequency: Tuning in an off-frequency station without moving the transmitter describes RIT (clarifier), not IF Shift.