Amateur Extra Question E4D01
E4D: Receiver performance characteristics: dynamic range; intermodulation and cross-modulation interference; third-order intercept; desensitization; preselector; sensitivity; link margin
What is meant by the blocking dynamic range of a receiver?
- The difference in dB between the noise floor and the level of an incoming signal that will cause 1 dB of gain compression (correct answer)
- The minimum difference in dB between the levels of two FM signals that will cause one signal to block the other
- The difference in dB between the noise floor and the third-order intercept point
- The minimum difference in dB between two signals which produce third-order intermodulation products greater than the noise floor
Correct answer: A, The difference in dB between the noise floor and the level of an incoming signal that will cause 1 dB of gain compression
Explanation
Blocking dynamic range is the span in dB from the receiver's noise floor (MDS) up to the level of an off-frequency signal that causes 1 dB of gain compression on the desired signal. A large BDR means the receiver can hear weak signals while a strong nearby signal is present, without being desensitized.
Why the other answers are wrong
- B, The minimum difference in dB between the levels of two FM signals that will cause one signal to block the other: FM capture effect describes one FM signal suppressing another; BDR is measured relative to the noise floor and gain compression, not between two FM signals.
- C, The difference in dB between the noise floor and the third-order intercept point: The intercept point is a calculated level well above where the receiver actually overloads, so the noise floor to intercept span does not define any dynamic range.
- D, The minimum difference in dB between two signals which produce third-order intermodulation products greater than the noise floor: Two signals producing third-order IMD at the noise floor defines the two-tone IMD dynamic range, a separate specification.