Amateur Extra Question E4D02
E4D: Receiver performance characteristics: dynamic range; intermodulation and cross-modulation interference; third-order intercept; desensitization; preselector; sensitivity; link margin
Which of the following describes problems caused by poor dynamic range in a receiver?
- Spurious signals caused by cross modulation and desensitization from strong adjacent signals (correct answer)
- Oscillator instability requiring frequent retuning and loss of ability to recover the opposite sideband
- Poor weak signal reception caused by insufficient local oscillator injection
- Oscillator instability and severe audio distortion of all but the strongest received signals
Correct answer: A, Spurious signals caused by cross modulation and desensitization from strong adjacent signals
Explanation
Strong signals can push a receiver with limited dynamic range into nonlinear operation. That causes cross modulation, where an unwanted signal's modulation appears on the desired signal, along with spurious responses. It also causes desensitization, where a strong nearby signal compresses gain and weak signals fade. Both come from overload, not from oscillator faults.
Why the other answers are wrong
- B, Oscillator instability requiring frequent retuning and loss of ability to recover the opposite sideband: Drift and needing to retune point to a poor VFO; sideband recovery depends on the filters and BFO, not on dynamic range.
- C, Poor weak signal reception caused by insufficient local oscillator injection: Low LO injection can hurt mixer performance, but dynamic range problems are about strong signals overloading stages, not weak injection.
- D, Oscillator instability and severe audio distortion of all but the strongest received signals: Oscillator instability is unrelated, and overload distorts things when strong signals are present, not 'all but the strongest' signals.