Amateur Extra Question E9E03
E9E: Impedance matching: matching antennas to feed lines; phasing lines; power dividers
What matching system uses a short length of transmission line connected in parallel with the feed line at or near the feed point?
- Gamma match
- Delta match
- T-match
- Stub match (correct answer)
Correct answer: D, Stub match
Explanation
A stub match places a short section of transmission line in parallel (shunt) with the feed line at or near the feed point. The stub can be shorted or open at its far end and is cut to a length that adds just enough reactance to cancel the load's reactance. Moving its attachment point along the line sets the resistive part to match the feed line's characteristic impedance.
Why the other answers are wrong
- A, Gamma match: A gamma match taps the driven element with a rod running parallel to it plus a series capacitor; it does not use a shunt section of transmission line.
- B, Delta match: A delta match fans the open-wire feed line out to two points on the driven element; it uses no separate parallel stub.
- C, T-match: A T-match is a balanced version of the gamma match with two tap rods on the element, not a shunt section of transmission line.