General Question G0B04
G0B: Station safety: electrical shock, grounding, fusing, interlocks, and wiring; antenna and tower safety
Where should the station’s lightning protection ground system be located?
- As close to the station equipment as possible
- Outside the building (correct answer)
- Next to the closest power pole
- Parallel to the water supply line
Correct answer: B, Outside the building
Explanation
Lightning ground rods belong outside the building, typically where feed lines and control cables enter. A surge can then be sent into the earth before it reaches the house. This ground must be bonded to the building's electrical service ground so all grounds stay at the same potential. The goal is to keep lightning energy out of the building, not to route it through the shack.
Why the other answers are wrong
- A, As close to the station equipment as possible: Grounding at the operating position would bring lightning current inside, right past the equipment and the operator.
- C, Next to the closest power pole: The power pole belongs to the utility; the station's protective ground should be at its own cable entry and bonded to the service ground.
- D, Parallel to the water supply line: Running alongside the water line gives no protection; plumbing may be plastic and is not a designed lightning path.