General Question G4A05
G4A: Station configuration and operation
Why is automatic level control (ALC) used with an RF power amplifier?
- To balance the transmitter audio frequency response
- To reduce harmonic radiation
- To prevent excessive drive (correct answer)
- To increase overall efficiency
Correct answer: C, To prevent excessive drive
Explanation
ALC sends a control voltage from the amplifier back to the exciter. When drive starts to get too high, that voltage turns the exciter's output down. This prevents overdriving the amplifier, which would cause flat-topping, splatter and distortion, and could stress the amplifier.
Why the other answers are wrong
- A, To balance the transmitter audio frequency response: Audio frequency response is shaped by transmit audio filtering or equalization, not by ALC.
- B, To reduce harmonic radiation: Harmonic suppression is the job of low-pass filtering and the output tank circuit; ALC only controls drive level.
- D, To increase overall efficiency: ALC limits drive to keep the amplifier linear; it does not raise the amplifier's efficiency.