General Question G4C08
G4C: Interference to consumer electronics; grounding and bonding
Which of the following would reduce RF interference caused by common-mode current on an audio cable?
- Place a ferrite choke on the cable (correct answer)
- Connect the center conductor to the shield of all cables to short circuit the RFI signal
- Ground the center conductor of the audio cable causing the interference
- Add an additional insulating jacket to the cable
Correct answer: A, Place a ferrite choke on the cable
Explanation
Common-mode current flows in the same direction on all conductors of a cable, including the outside of the shield, so the cable acts as an antenna. A ferrite choke (a clamp-on core or several turns through a toroid) adds high impedance to that common-mode path. The wanted audio is differential, so its fields cancel in the core and it passes almost unaffected.
Why the other answers are wrong
- B, Connect the center conductor to the shield of all cables to short circuit the RFI signal: Shorting the center conductor to the shield kills the audio signal itself. It also does nothing about current on the shield's outside.
- C, Ground the center conductor of the audio cable causing the interference: Grounding the center conductor shorts out the audio, and common-mode RF would still flow on the cable.
- D, Add an additional insulating jacket to the cable: Plastic insulation is transparent to RF and has no effect on current flowing along the conductors.