General Question G4C10
G4C: Interference to consumer electronics; grounding and bonding
What could be a symptom caused by a ground loop in your station’s audio connections?
- You receive reports of “hum” on your station’s transmitted signal (correct answer)
- The SWR reading for one or more antennas is suddenly very high
- An item of station equipment starts to draw excessive amounts of current
- You receive reports of harmonic interference from your station
Correct answer: A, You receive reports of “hum” on your station’s transmitted signal
Explanation
A ground loop in audio wiring lets small AC currents from the power line flow through cable shields. The microphone or computer audio path picks this up as a low-pitched 60 Hz or 120 Hz hum, and the transmitter sends it out with your voice. Stations reporting hum on your signal is the classic sign. Bonding enclosures and breaking the loop, for example with an audio isolation transformer, usually cures it.
Why the other answers are wrong
- B, The SWR reading for one or more antennas is suddenly very high: A sudden SWR jump points to a feed line, connector or antenna fault. An audio ground loop does not change the load impedance.
- C, An item of station equipment starts to draw excessive amounts of current: Excessive current draw signals an internal fault or short in that equipment. Ground loop currents in audio shields are tiny.
- D, You receive reports of harmonic interference from your station: Harmonics come from nonlinear transmitter stages and poor output filtering, not from hum picked up in audio cabling.