General Question G4C11
G4C: Interference to consumer electronics; grounding and bonding
What technique helps to minimize RF “hot spots” in an amateur station?
- Building all equipment in a metal enclosure
- Using surge suppressor power outlets
- Bonding all equipment enclosures together (correct answer)
- Placing low-pass filters on all feed lines
Correct answer: C, Bonding all equipment enclosures together
Explanation
RF hot spots are places where a chassis, microphone or key carries RF voltage, so you may feel an RF burn or get feedback. They appear when equipment cases sit at different RF potentials. Bonding all enclosures together with short, wide conductors keeps them at a common RF potential, which removes those voltage differences.
Why the other answers are wrong
- A, Building all equipment in a metal enclosure: A metal case shields what is inside it, but separate unbonded cases can still sit at different RF potentials from one another.
- B, Using surge suppressor power outlets: Surge suppressor outlets clamp power line transients. They do not equalize RF voltage between pieces of equipment.
- D, Placing low-pass filters on all feed lines: Low-pass filters cut transmitted harmonics on the feed line. They do not stop RF currents on enclosures and cables inside the shack.