Technician Question T0A07
T0A: Power circuits and hazards: hazardous voltages, fuses and circuit breakers, grounding, electrical code compliance; Lightning protection; Battery safety
Where should a lightning arrester be installed in a coaxial feed line?
- At the output connector of a transceiver
- At the antenna feed point
- At the AC power service panel
- On a grounded panel near where feed lines enter the building (correct answer)
Correct answer: D, On a grounded panel near where feed lines enter the building
Explanation
A lightning arrester belongs on a grounded entrance panel where the feed lines come into the building. That way surge energy is sent to ground before it reaches the interior wiring or your equipment. The panel should bond to the station's lightning ground system, so the surge takes a short, direct path outside the house.
Why the other answers are wrong
- A, At the output connector of a transceiver: At the transceiver, the surge has already entered the building and its wiring; it should be diverted before it comes inside.
- B, At the antenna feed point: An arrester at the feed point leaves the whole feed line run unprotected and is hard to ground well; protection belongs at the building entry.
- C, At the AC power service panel: The AC service panel handles power-line surges, and coax shouldn't be routed there; feed line arresters go where the feed lines enter.